![]() ![]() People that used this guide please let me know wich scanner you have and that you had to configure additional stuff to make it work. The autostart works finally so this tuturial is completely finished I hope it will be soon a standard stuff of my qnap. I spend lots of time to make this working and i am glad i can share it with you guys. On the website you have all the information you need to install it and how to use it. I'm using it now on my system because it seems to be more stable then Xsan for windows If all is fine now you can start the software: The file nf is also good and doesn't need any changes. # may be necessary to access devices that need special privileges. # If you list "localhost" then your backends can be accessed either So if this is all working all on Qnap is configured Now.Ĭode: Select all # This is the net config file. When it does it's not possible to use your scanner.Ĭode: Select all ~] # /opt/sbin/xinetd DEBUG: 1493 active_services = 1 ![]() You can try to scan a testpage, this doesn't workd for my but with the command scanimage -L you may not recieve any error. # Most Scanners connected to the parallel port or other proprietary ports ![]() # Not checking for parallel port scanners. Try scanimage -L and read the backend's manpage. # Your USB scanner was (probably) detected. # you have loaded a kernel SCSI driver for your SCSI adapter.įound USB scanner (vendor=0x04b8, product=0x080f ) at libusb:00 THIS LINE IS IMPORTANT If you expected something different, make sure that # scanner is powered up and properly connected to your computer. # result is different from what you expected, first make sure your # sane-find-scanner will now attempt to detect your scanner. Save the file : first press few times on the ESC button # the saned daemon as documented in saned(8), services(4)ġ92.168.1.0/24 #grant access to scanner from network 192.168.1.x THIS LINE IS ONLY THAT IS IMPORTANT # /etc/services must also be properly configured to start # The hostname matching is not case-sensitive. # always be specified in their compressed form. IPv6 addresses must be enclosed in brackets, and should # addresses or IP subnets (CIDR notation) that are permitted to use local # The contents of the nf file is a list of host names, IP On some systems like the QNAP TS210 i get an error after install when using the ipkg command: I will not explain how to do that because you can find all that information here on the forum. NOTE: I DON'T TAKE ANY RESPONSIBILITY IF SOMETHING GOES WRONG WITH YOUR DEVICE OR IF YOU LOOSE DATA.įirst of al i installed QPKG. When more people like this feature maybe i will consider to write a tutorial when i have the time. You have to configure it also in the same way as for Qnap NAS. Then i searched for a frontend: I used Xsane, that is supported for windows. Then install sane-backends and xinetd, configure it for your network. FIXEDĪll what you need is installing Qpkg on your qnap. The error comes for the group, Still don't know why but i'm looking for it. I used the name : admin and for the group : admin. When i start it manaually sane backend server start but it gives still a error. I edit the autorun.sh script for starting de xinetd but it doesn't start at boot. I have got it working but i have still a problem to start it automatically. Sane is a project to use an usb or scsci or parralell port scanner on a server and acces it with other computers over the network. After long searching and trying i have got sane working on my qnap TS209 pro ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |